Komatsu — BLEEDING AIR

TESTING AND ADJUSTING BLEEDING AIR BLEEDING AIR ORDER FOR OPERATIONS AND PROCEDURE FOR BLEEDING AIR Note: Bleed the air from the swing and travel motors only when the oil inside the motor case has been drained. 1. Bleeding air from pump 1) Loosen air bleed plug (1), and check that oil oozes out from the plug. 2) When oil oozes out, tighten plug (1). Plug: 17.25 ± 2.5 Nm {1.75 ± 0.25 kgm} # If no oil oozes out from the air bleed plug: 3) Leave plug (1) loosened and remove hose (2) and elbow (3). 4) Pour in oil through the elbow mount hole until oil oozes out from plug (1). 5) Fit elbow (3) and install hose (2). 6) Tighten air bleed plug (1). Plug:

17.25 ± 2.5 Nm {1.75 ± 0.25 kgm} # Precautions when starting the engine After completing the above procedure and start- ing the engine, run the engine at low idling for 10 minutes. # If coolant temperature is low and automatic warming-up is carried out, cancel it by using the fuel control dial after starting the engine.

20-47 Airbleedingitem Natureofwork Airbleedingprocedure 1 2 3 4 5 6 Bleedingairfrom pump Startengine Bleedingairfrom cylinder Bleedingairfrom swingmotor Bleedingairfrom travelmotor Startoperations •Replacehydraulicoil •Cleanstrainer      (note)  (note) •Replacereturnfilterelement   (note) •Replace,repairpump •Removesuctionpiping     (note) •Replace,repaircontrolvalve    (note) •Replacecylinder •Removecylinderpiping    (note) •Replaceswingmotor •Removeswingmotorpiping    (note) •Replacetravelmotor,swivel •Removetravelmotor,swivel   (note)  (note)