Komatsu — POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE

TROUBLESHOOTING POINTS TO REMEMBER WHEN CARRYING OUT MAINTENANCE Drying wiring harness If there is any oil or dirt on the wiring harness, wipe it of with a dry cloth. Avoid washing it in water or using steam. If the connector must be washed in water, do not use high-pressure water or steam directly on the wiring harness. If water gets directly on the connector, do as follows. 1) Disconnect the connector and wipe off the water with a dry cloth. # If the connector is blown dry with com- pressed air, there is the risk that oil in the air may cause defective contact, so remove all oil and water from the compressed air before blowing with air. 2) Dry inside of the connector with a dryer.

If water gets inside the connector, use a dryer to dry the connector. # Hot air from the dryer can be used, but regu- late the time that the hot air is used in order not to make the connector or related parts too hot, as this will cause deformation or damage to the connector. 3) Carry out a continuity test on the connector. After drying, leave the wiring harness disconnected and carry out a continuity test to check for any short circuits between pins caused by water. # After completely drying the connector, blow it with contact restorer and reassemble. 20-60