TROUBLESHOOTING DETAILS OF TROUBLESHOOTING AND TROUBLESHOOTING PROCEDURE DETAILS OF TROUBLESHOOTING AND TROUBLESHOOTING PROCEDURE If any abnormality should occur, it is necessary to go to the correct troubleshooting chart in accordance with the judgement table for that type of failure (engine throttle - pump controller (governor control system) and engine throttle - pump controller (pump control system). For details of the troubleshooting and troubleshooting proce- dure, refer to this flow chart. When carrying out troubleshooting procedure, ask the operator as much as possible about the condition of the machine, and check the following items before starting.
(1) Condition of controller connection (check with monitoring codes 02 - 03) (2) Blow fuses (3) Battery voltage (monitoring mode 32) (4) Electricity generation (charge input) voltage (monitoring code 43) The procedure for carrying out check items No. 3 and 4 in the flow chart below is given on the following pages. YES E02 (TVC system) E03 (Swing holding brake system) E05 (Governor motor system) } Go to Item 2 1 Is user code displayed on monitor panel? YES E2 group: Troubleshooting for governor, pump controller (pump control system) (C mode) E3 group: Troubleshooting for governor, pump controller (governor control system) (E mode) Carry out troubleshooting in applicable mode (Note:
For E218, carry out troubleshooting of the communication ab- normality system (N mode.) } Carry out troubleshoot- ing for engi- ne (S mode) Carry out troubleshoot- ing for eng- ine electrical system (E mode). (use flow chart for items where there is no display) (E11 - E15) 6 YES 2 Engine system 5 Is engine electrical system for which there is no failure code display normal? Is service code displayed on monitor panel? YES Is problem in engine system of hydraulic (mechanical) system? NO Go to flow chart for section where there is no abnormality display on judgment table. NO Operate and check service code. 4 After adjusting oil pressure, judge from engine speed.
Is all work equipment slow and does engine speed drop under heavy load? Hydraulic (mechani- cal) system Carry out trouble- shooting for hydraulic (mechanical) system (H mode) YES Are governor, pump controller input and output signals normal? Check using monitoring code. Governor controller: 30,31,33,34 Pump controller: 10 - 24 Valve controller: 50 - 69 Carry out troubleshooting for communication abnormality system (N comde). 3 Carry out troubleshooting for input signal system (F mode). NO Are monitor codes 02, 03, 08 normal? NO Check connection condition of S-NET in monitoring codes 02,03,08.
NO # For details, see governor, pump controller (governor control system) (pump control system) in the JUDGE- MENT TABLE. 20-97 C tr in in s m (u