Komatsu — M- 9 When starting switch is turned ON ( engine stops), basis check items flash

TROUBLESHOOTING TESTING AND ADJUSTING METHOD OF USING TROUBLESHOOTING CHARTS (1) M-9 When starting switch is turned ON (engine stops), basis check items flash (4) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. (2) a) (coolant level) flashes # Check that the coolant level is correct before carrying out troubleshooting. b) (engine oil level) flashes # Check that the engine oil level is correct before carrying out troubleshooting. (3) Table 20-96 YES 1 Does display go out 4YES when short connec- tor is connected to Is bit (3) of P08 (female)?

YES monitoring code 24 3 lighted up? • Disconnect P08. Is continuity between • T Ou Nrn . starting switch YES C ch1 a6 s ( sf ie sm aa sl e s) h o(8 w) na n ind • Turn starting switch NO ON. 2 table? • Set to monitoring code 24. Is there continuity • Turn starting switch between P08 (female) OFF. NO NO (2) and chassis? • disconnect C16, P08. • Connect  disconnect short connector to P08 • Turn starting switch (female). OFF. • Disconnect P08.

NO Cause Remedy Defective coolant level sensor system (see M-26) Defective governor, pump controller Defective monitor panel Defective contact, or disconnection in wiring harness between C16 (female) (8) -P08 (female) (1) Defective contact, or disconnection in wiring harness between P08 (female) (2) - chassis ground - Replace Replace Repair or replace Repair or replace Short connector Continuity Connected Yes Disconnected No