Komatsu — METHOD OF USING TROUBLESHOOTING CHARTS

TROUBLESHOOTING TESTING AND ADJUSTING METHOD OF USING TROUBLESHOOTING CHARTS METHOD OF USING TROUBLESHOOTING CHARTS 1. Category of troubleshooting code number 2. Method of using troubleshooting table for each troubleshooting mode (1) Troubleshooting code number and problem (for (1) - (4), see the examples on the next page.) The title at the top of the troubleshooting chart gives the troubleshooting code and failure mode (prob- lem with the machine). (2) Distinguishing conditions Even with the same failure mode (problem), the method of troubleshooting may differ according to the model, component, or problem.

In such cases, the failure mode (problem) is further divided into sec- tions marked with small letters (for example, a)), so go to the appropriate section to carry out trouble- shooting. If the troubleshooting table is not divided into sections, start troubleshooting from the first check item in the failure mode. (3) Method of following troubleshooting chart Check or measure the item inside , and according to the answer follow either the YES line or the NO line to go to the next . (Note:

The number written at the top right corner of the is an index number; it does not indicate the order to follow.) Following the YES or NO lines according to the results of the check or measurement will lead finally to the Cause column. Check the cause and take the action given in the Remedy column on the right. Below the there are the methods for inspection or measurement, and the judgement val- ues. If the judgement values below the are correct or the answer to the question inside the is YES, follow the YES line; if the judgement value is not correct, or the answer to the question is NO, follow the NO line.

Below the is given the preparatory work needed for inspection and measurement, and the judgement values. If this preparatory work is neglected, or the method of operation or handling is mistaken, there is danger that is may cause mistaken judgement, or the equipment may be dam- aged. Therefore, before starting inspection or measurement, always read the instructions care- fully, and start the work in order from Item 1). (4) General precautions When carrying out troubleshooting for the failure mode (problem), precautions that apply to all items are given at the top of the page and marked with # .

The precautions marked # are not given in the , but must always be followed when carrying out the check inside the . (5) Troubleshooting tools When carrying out the troubleshooting, prepare the necessary troubleshooting tools. For details, see TOOLS FOR TESTING, ADJUSTING, AND TROUBLESHOOTING. (6) Installation position, pin number A diagram or chart is given for the connector type, installation position, and connector pin number. When carrying out troubleshooting, see this chart for details of the location for inspection and measure- ment of the wiring connector CNOO appearing in the troubleshooting flow chart for each failure mode (problem). YES NO 20-95 Troubleshooting CodeNo.

Component Servicecode C- Troubleshootingofenginethrottle,pumpcontroller(Pumpcontrolsystem) E2-system E- Troubleshootingofenginethrottle,pumpcontroller(Governorcontrolsystem) E3-system F- Troubleshootingofenginethrottle,[Inputsinglesystem] - H- Troubleshootingofhydraulic,mechanicalsystem - M- Troubleshootingofmachinemonitorpanelsystem E1-system N- Troubleshootingofcommunicationssystem E218system S- Troubleshootingofenginesystem -