Komatsu — DETAILS OF TROUBLESHOOTING AND TROUBLESHOOTING PROCEDURE

TROUBLESHOOTING DETAILS OF TROUBLESHOOTING AND TROUBLESHOOTING PROCEDURE 3. Checking travel speed selection signal 1) Set to the monitoring mode and display monitoring code 23. 2) Change the speed selector switch to Hi or Mi and run the engine at 1500 rpm or above. Check that bit (6) lights up when traveling at Hi or Mi (pump oil pressure: 17.7 - 23.5 MPa {180 - 240 kg/cm 2 } 2. Checking input signal of engine throttle - pump controller # Check the input signals for each controller as follows. Pump control system 1. Checking input signal 1) Check hydraulic switch i) Set to the monitoring mode, and display monitoring codes 20 and 21.

ii) Operate each work equipment lever, and check how the bit pattern lights up. # For details of the bit pattern chart, see MONITOR PANEL DISPLAY AND SPECIAL FUNCTIONS. 2) Check speed sensor (check engine speed) i) Set to the monitoring mode, and display monitoring code 10. ii) Use the fuel control dial to change the speed, and measure the speed when this is done. 3) Check pump discharge pressure sensor i) Set to the monitoring mode, and display monitoring code 11. 20-99