Komatsu — E- 7 [ E316] Abnormality ( step- out) in motor is displayed

TROUBLESHOOTING E-7 E-7 [E316] Abnormality (step-out) in motor is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # If any other service code [E306] - [E318] has occured at the same time, start troubleshooting from the code exept code [E316]. # Check that the fuse is normal. # Read the precautions given in TESTING AND ADJUSTING, "Adjusting travel of governor motor lever" before carrying out the troubleshooting.

# Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. 20-122 YES 1 YES 3 Are E306, E317, and Operate fuel control E318 displayed? YES dial 0 MAX and turn starting switch OFF. 4 YES Is operation normal? • Turn starting switch 2 Is there any scuffing ON. • Turn starting switch when spring rod is ON. moved to injection NO Is adjustment of • Turn auto decelera- pump end? NO linkage normal? tion OFF. • Disconnect E05 NO • Disconnect linkage at • Turn starting switch governor motor end. ON. • Turn autodeceleration NO OFF. • Set to governor motor adjustment mode.

• See TESTING AND ADJUSTING. Cause Remedy Go to applicable failure mode Defective governor, pump controller 1) Defective linkage 2) Defective injection pump Defective governor motor Defective governor linkage - Replace Adjust or replace Replace Adjust (For details, see TESTING AND ADJUSTING)