TROUBLESHOOTING E-6 E-6 [E315] Abnormality (short circuit) in battery relay output system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its oringinal position, if the service code E is not displayed, the problem has been removed. Check with the engine stopped (push the fuel control lever of the fuel injection pump to the NO INJECTION position. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step.
# This only occurs when the engine is stopped and the starting switch is turned OFF. E-6 Related electric circuit diagram X07 (MIC17) M11 (L2) Fuse box Starter switch (KES1.2) Battery relay drive 20-121 YES 1 Is resistance between C01 (female) (1) and 2 YES chassis normal? Is resistance between • Between C01 C01 (female) (1) and bat- (female) (1) and NO tery relay terminal BR, and between wiring har- chassis: Approx. ness and chassis normal? 110 • Turn starting switch • Between C01 NO OFF. (female) (1) and • Disconnect C01. battery relay BR: Max 1 • Between wiring harness and chassis: Min. 1 M • Turn starting switch OFF. • Disconnect C01 and battery relay BR.
Cause Remedy Defective governor, pump controller Defective battery relay 1) Contact between other wiring harness and wiring harness between C01 (fe- male) (1)-battery relay BR. 2) When light is connected Replace Replace Replace