TROUBLESHOOTING E-5 E-5 [E306] Abnormality in feedback potentiometer system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code E is not displayed, the problem has been removed. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. # If E308 also occurs at the same time, check the wiring harness below.
Wiring harness between C03 (female) (7) - x07 (6) - E06 (female) (1) short circuiting with ground, or contact with other wiring harness Table 1 E-5 Related electric circuit diagram 20-120 2 YES Is resistance between each YES pin of C03 (female) (4) (7) (14), or between each pin 1 and chassis as shown in Table 1? Is resistance between E06 (male) • Turn starting switch NO (1)-(2), (2)-(3) as OFF. shown in Table 1? • Disconnecting C03. Turn starting switch OFF. NO Disconnecting E04.
Cause Remedy Defective governor, pump controller Defective wiring harness in system with defective resistance Defective governor motor Replace Replace Replace C03 (female) E04 (male) Resistance value (7) - (4) (1) - (2) 0.25 - 7k (14) - (17) (2) - (3) 0.25 - 7k (7) - (17) - 2 - 3k - (1) - (3) 4 - 6k Betweeneach pinandchassis - Min. 1 M