TESTING AND ADJUSTING JUDGEMENT TABLE FOR PUMP CONTROLLER AND HYDRAULIC RELATED PARTS JUDGEMENT TABLE FOR PUMP CONTROLLER AND HYDRAULIC RELATED PARTS :This shows item that needs only checking with monitoring :This shows applicable item for service code : This shows item to check with monitoring or machine monitor 20-170 User code Failure Mode Service code Abnormality in controller power source Engi ne thr ottle, pump cont roller (E2:
XX sys tem) Sel f-diag nosti c disp lay Short circuit in PC-EPC solenoid system Disconnection in PC-EPC solenoid system Short circuit in swing holding brake solenoid system Disconnection in swing holding brake solenoid system Short circuit in 2-stage relief solenoid system Disconnection in 2-stage relief solenoid system Short circuit in travel speed solenoid system Disconnection in travel speed solenoid system Model selection input error User code E0 2 - E 03 - Service code 232 233 203 213 205 215 206 216 217 All work equipment, travel swing Speeds of all work equipment, swing, travel are slow or lack power There is excessive drop in engine speed, or engine stalls No work equipment, travel, swing move Abnormal noise generated (around pump) Auto-deceleration does not work Fine control ability is poor or response is poor Work equipment Boom is slow or lacks power Arm is slow or lacks power Bucket is slow or lacks power Boom does not move Arm does not move Bucket does not move Excessive hydraulic drift Excessive time lag (engine at low idling) Lack of power when pressure rises Other equipment moves when single circuit is relieved Compound operations In F/O mode, arm IN speed is faster than specified speed In compound operations, work equipment with larger load is slow Travel system Travel speed is slow Travel speed does not switch or is faster than specified speed Swing system Does not swing Both left and right One direction only Swing acceleration is poor or swing speed is low Both left and right One direction only Excessive overrun when stopping swing Both left and right One direction only Excessive shock when stopping swing (one direction only) Excessive abnormal noise when stopping swing Excessive hydraulic drift of swing When swing holding brake is canceled When swing holding brake is applied Swing speed is faster than specified swing speed Troubleshooting code when service code is displayed C-1 C-2 C-3 C-4 C-5 C-6 C-7 C-8 C-9 C-12 Troubleshooting code when there is abnormality in monitoring code check - - - - - - - - - -