TESTING AND ADJUSTING C-8 C-8 [E206] Short circuit in travel speed solenoid system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check that the service code "E" is displayed. (If it is not displayed, the problem has been removed.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted.
# Always connect any disconnected connectors before going on to the next step. Wheels rotated at full speed under no load Table 1 Between V06 (male) (1) and (2) 20 - 60 Ω Between V06 (male) (2) and chassis Min. 1 M Ω C-8 Related electrical circuit diagram (KES1.2) 20-185 3 YES Is resistance YES between C01 2 (female) (9) and Is resistance chassis normal? YES between V06 (male) • Turn starting switch NO (1) and (2), (2) and OFF 1 chassis as shown in • Disconnect C01 Table 1? • Turn swing lock switch OFF Interchange • Turn starting switch • 20 - 60 Ω connector with other OFF solenoid. Is [E206] • Disconnect V06 NO displayed?
• Turn starting switch OFF • Interchange V06 with NO other solenoid • Start engine • Travel speed switch: Hi Cause Remedy Defective engine throttle, pump controller Wiring harness between C01 (female) (9) and V06 (female) (1) short circuiting with chassis ground Defective travel speed solenoid (internal short circuit, short circuit with chassis ground) Replace Repair or replace Replace