TESTING AND ADJUSTING C-7 C-7 [E215] Disconnection in 2-stage relief solenoid system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check that the service code "E" is displayed. (If it is not displayed, the problem has been removed.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted.
# Always connect any disconnected connectors before going on to the next step. Table 1 C-7 Related electrical circuit diagram A04 (KES1.2) 2. Step relief 20-184 4 YES Is voltage between YES V05 (female) (10) and chassis as 3 shown in Table 1? • Turn starting switch NO Is voltage between ON YES C01 (male) (10) and • Disconnect V05 2 chassis as shown in Table 1? Is resistance YES between V05 (male) • Turn starting switch NO 1 (1) and (2) normal? ON • Disconnect C01 Interchange • Turn starting switch connector with other OFF NO solenoid. Is [E215] • Disconnect V05 displayed?
• 20 - 60 Ω • Turn starting switch OFF • Interchange V05 with NO other solenoid • Turn starting switch ON Cause Remedy Defective contact or disconnection in wiring harness between V05 (female) (2) and chassis ground Defective contact or disconnection in wiring harness between C01 (female) (10) and V05 (female) (1), or short circuit with power source Defective engine throttle, pump controller Defective 2-stage relief solenoid (internal disconnection, short circuit with power source) Repair or replace Repair or replace Replace Replace Troubleshooting3 Troubleshooting4 Voltage Measurementcondition BetweenC01(male)(10) andchassis BetweenV05(female)(2) andchassis 0-3V Allcontrolleversatneutral 20-30V Whencontrolleverisoperated+powermax.
switchON