TESTING AND ADJUSTING C15 C15 [E224] Abnormality in pump pressure sensor system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check that the service code "E" is displayed. (If it is not displayed, the problem has been removed.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted.
# Always connect any disconnected connectors before going on to the next step. C-15 Related electrical circuit diagram 20-190 YES 4YES YES Is resistance 1 between C08 (3) and 3 chassis normal? Is voltage between Is voltage between C03 (3) and (16) as YES C08 (1) and chassis • Turn starting switch NO shown in Table 1? normal? OFF • Disconnect C03 and • Engine at high idling C08 • Operate lever 2 • Turn starting switch • Min. 1 MO OFF repeatedly between Is voltage between NO • Disconnect C08 arm IN relief and C08 (2) and chassis • Max. 1 O HOLD normal?
NO • 0.5 - 4.5 Vc • Disconnect C08 NO • Turn starting switch ON • 18 - 28 V Cause Remedy Defective engine throttle, pump controller Defective pump pressure sensor (internal disconnection, defective contact, short circuit, short circuit with ground) Short circuit with chassis ground, short circuit with power source, defective contact, or disconnection in wiring between C03 (female) (3) and C08 (female) (3) Short circuit, defective contact, or disconnection in wiring harness between C03 (female) (16) and C08 (female) (1) Short circuit, defective contact, or disconnection in wiring harness between C03 (female) (6) and C08 (female) (2) Replace Repair or replace Repair or replace Repair or replace Replace