Komatsu — C- 17 [ E227] Abnormality in engine speed sensor system is displayed

TESTING AND ADJUSTING C-20 C-17 [E227] Abnormality in engine speed sensor system is displayed # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the service code "E" is not displayed, the problem has been removed. # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check that the service code "E" is displayed. (If it is not displayed, the problem has been removed.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted.

# Always connect any disconnected connectors before going on to the next step. 2 Is resistance between C16 (female) 91) and (2) normal? YES Defective governor, pump controller Replace YES 1 Short circuit with ground, defective contact or disconnection in wiring harness between C16 (female) (1) - E08 (10) - E07 (female) (2), or between C16 (female) (2) - E08 (9) - E07 (female) (1) Repair or replace Is resistance between E07 (male) 91) and (2) normal?

Turn starting switch OFF Disconnect C16 500 - 1000 Ω NO Turn starting switch OFF Disconnect E07 500 - 1000 Ω NO Defective engine speed sensor (internal disconnection, defective contact, or short circuit with ground) Replace C-17 Related electrical circuit diagram 20-192 Cause Remedy