TESTING AND ADJUSTING F-8 F-8 Bit pattern 21-(2) Bucket DUMP oil pressure switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T- adapter and returning the connector to its original position, if the monitoring mode display returns to normal, the problem has been removed. When measuring with the engine running, make sure that the work equipment does not move when the lever is operated.
(When measuring with the engine stopped, charge the accumulator before starting.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. Note 1: It is also possible to fit a short connector and judge the condition. In this case, check the volt- age between C16 (12) and the chassis. If it is 20-30V: Go to YES If it is less than 1V: Go to NO F-8 Related electrical circuit diagram 20-203 YES 1 Is voltage between 3 YES C16 (12) and chassis Is resistance between normal? C16 (female) (12) and YES S07 (female) (2) normal, • Start engine.
2 and is circuit insulated • Bucket lever at Is resistance between from chassis? • H BuO cL kD et: l2 e0 v- e3 r0V NO S no0 r7 m ( am l,a ale n) d ( 1 is) ca in rcd u ( it2) • • T Du isr cn o s nta nr et cin t g C s 1w 6i t ac nh d O SF 0F 7. .NO operated to insulated from • Between C16 and S07: Max. 1 Ω DUMP: Max. 1V chassis? • Between wiring harness and chassis: Min. 1 MΩ • Disconnect S07 • Start engine NO • Bucket lever at HOLD: Min. 1 MΩ • Bucket lever operated to DUMP: Max. 1 Ω Cause Remedy Defective engine throttle, pump controller.
Defective contact, or disconnection in wiring harness between S07 (female) (2) and chassis ground Short circuit with chassis ground, defective contact, or disconnection in wiring harness between C16 (female) (12) and S07 (female) (2). Defective bucket DUMP oil pressure switch (If condition does not return to normal even when switch is replaced, go to H- 5) Replace Repair or replace Repair or replace Replace