TESTING AND ADJUSTING F-9 F-9 Bit pattern 21-(3) Swing lock switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the monitoring mode display returns to normal, the problem has been removers. # If the panel display is normal (if the panel swing lock lamp does not light up, go to M- 21) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step.
F-9 Related electrical circuit diagram 20-204 YES 1 Is voltage between 3 YES C17 (16) and chassis Is resistance between normal? C17 (female) (16) and YES X05 (female) (1) normal, • Turn starting switch 2 and is circuit insulated ON Is resistance between from chassis? • S Ow Ni :n Mg alo xc . k 1 Vsw Oit Fc Fh : NO X (20 ) 5 n ( of re mm aa l,le a) n ( d1 ) i sand • • T Du isr cn o s nta nr et cin t g C s 1w 7i t ac nh d O XF 0F 5.NO 20-30V circuit insulated from • Between C17 and X05: Max. 1 Ω chassis? • Between wiring harness and chassis: Min. 1 MΩ • Turn starting switch OFF NO • Disconnect X05 • Swing lock switch ON: Max. 1Ω OFF: Min.
1 MΩ Cause Remedy Defective engine throttle, pump controller. Short circuit with chassis ground, defective contact, or disconnection in wiring harness between X05 (female) (2) - X01 (5) - H14 (6) - chassis ground Short circuit with chassis ground, defective contact, or disonnection in wiring harness between C17 (female) (16) - X01 (4) - X05 (male) (1) Defective swing lock switch Replace Repair or replace Repair or replace Replace