Komatsu — F- 11 Bit pattern 22-( 6) L. H. knob switch does not light up

TESTING AND ADJUSTING F-11 F-11 Bit pattern 22-(6) L.H. knob switch does not light up # This troubleshooting is carried out when there is still an abnormality, so when disconnecting the connector and inserting the T-adapter, or when removing the T-adapter and returning the connector to its original position, if the monitoring mode display returns to normal, the problem has been removed. # Check that fuse 5 is normal. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next. F-11 Related electrical circuit diagram 20-205 YES 1 Is voltage between 3 YES C03 (9) and chassis normal?

Is resistance of knob YES switch terminal • Turn starting switch 2 normal? ON. Is voltage between • K 20n -o 3b 0 Vswitch ON: NO k ten ro mb i ns aw l i atc nh d i n cl he at ssis • T swur itn c hst Oar Fti Fng NO • Knob switch OFF: normal? • Disconnect switch terminal Max. 1V • Knob switch ON: Max. 1 Ω • Turn starting switch • Knob switch OFF: Min. 1 MΩ ON NO • 20-30V Cause Remedy Defective engine throttle, pump controller Defective contact, or disconnection in wiring harness between knob switch outlet - M23 (2) - M22 (2) - C03 (female) (9) Defective L.H. knob switch Defective contact, or disconnection in wiring harness between fuse 5 - H12 (16) - M22 (1) - H23 (1) - knob switch inlet.

Replace Repair wiring harness Replace Repair wiring harness