Komatsu — F- 11 Bit pattern 22-( 6) L. H. knob switch does not light up

TESTING AND ADJUSTING TROUBLESHOOTING OF HYDRAULIC, MECHANICAL SYSTEM (H MODE) Table of failure modes and causes.......................................................................................................... 20-205 All work equipment, travel, swing H- 1 Speeds of all work equipment, swing, travel are slow or lack power ........................................ 20-210 H- 2 There is excessive drop in engine speed, or engine stalls ....................................................... 20-212 H- 3 No work equipment, travel, swing move ...................................................................................

20-213 H- 4 Abnormal noise generated (around pump) ............................................................................... 20-213 H- 5 Auto-deceleration does not work .............................................................................................. 20-214 H- 6 Fine control ability is poor or response is poor ......................................................................... 20-214 Work equipment H- 7 Boom is slow or lacks power ....................................................................................................

20-216 H- 8 Arm is slow or lacks power ....................................................................................................... 20-218 H- 9 Bucket is slow or lacks power ................................................................................................... 20-220 H- 10 Work equipment (boom, arm bucket) does not move ............................................................... 20-221 H- 12 Excessive time lag (engine at low idling) .................................................................................. 20-222 H- 11 Excessive hydraulic drift (boom, arm, bucket) ..........................................................................

20-221 H- 13 Other equipment moves when single circuit is relieved ............................................................ 20-222 H- 14 In F/O modes, work equipment speed is faster than set speed............................................... 20-223 H- 15 Lack of power when pressure rises .......................................................................................... 20-223 Compound operations H- 16 In compound operations, work equipment with larger load is slow........................................... 20-223 Travel system H- 17 Travel speed is low ...................................................................................................................

20-224 H- 18 Travel speed does not switch or is faster than set speed ......................................................... 20-226 Swing system H- 19 Does not swing (both left and right, one direction only) ............................................................ 20-227 H- 20 Swing acceleration is poor or swing speed is slow (both left and right, one direction only) ..... 20-228 H- 21 Excessive overrun when stopping swing (both left and right, one direction only)..................... 20-230 H- 22 Excessive shock when stopping swing (one direction only) .....................................................

20-231 H- 23 Excessive abnormal noise when stopping swing...................................................................... 20-231 H- 24 Excessive hydraulic drift of swing (when brake is ON, when brake is OFF)............................. 20-232 H- 25 Swing speed is faster than specified speed.............................................................................. 20-233 20-207