Komatsu — TABLE OF FAILURE MODES AND CAUSES FOR HYDRAULIC AND MECHANICAL SYSTEM

TESTING AND ADJUSTING TABLE OF FAILURE MODES AND CAUSES FOR HYDRAULIC AND MECHANICAL SYSTEM TABLE OF FAILURE MODES AND CAUSES FOR HYDRAULIC AND MECHANICAL SYSTEM 20-208 Failure Mode Pu mp PPC pressure reducing valve Strainer PTO spline Co ntrol v alve PC-EPC valve LS valve Servo piston Pump proper Spool Unload valve Main relief valve Pressure compensation valve LS select valve LS circuit throttle Boom lock valve Regeneration valve Boom Arm All work equipment, travel swing Speeds of all work equipment, swing, travel are slow or lack power       There is excessive drop in engine speed, or engine stalls   No work equipment, travel, swing move    Abnormal noise generated (around pump)   Auto-deceleration does not work Fine control ability is poor or response is poor   Work equipment Boom is slow or lacks power     Arm is slow or lacks power    Bucket is slow or lacks power   Boom does not move   Arm does not move  Bucket does not move  Excessive hydraulic drift    Excessive time lag (engine at low idling)  Lack of power when pressure rises  Other equipment moves when single circuit is relieved  Compound operations In F/O mode, arm IN speed is faster than specified speed  In compound operations, work equipment with larger load is slow  Travel system Travel speed is slow   Travel speed does not switch or is faster than specified speed Swing system Does not swing Both left and right One direction only  Swing acceleration is poor or swing speed is low Both left and right One direction only   Excessive overrun when stopping swing Both left and right One direction only  Excessive shock when stopping swing (one direction only)  Excessive abnormal noise when stopping swing Excessive hydraulic drift of swing When brake is ON   When brake is OFF  Swing speed is faster than specified swing speed # :

In the failure modes, modes for compound operations are used when independet operation  : Main cause  : Secondary cause s are ma nual