Komatsu — H- 2 There is excessive drop in engine speed, or engine stalls

TESTING AND ADJUSTING H-2 H-2 There is excessive drop in engine speed, or engine stalls # Carry out troubleshooting in the heavy-duty operation mode. # Check that the main relief pressure is normal. Replace the servo valve assembly with a new part, and if the engine speed is lower than the value in Table 1, carry out troubleshooting for S mode. If it is higher, it can be judged that the PC valve (servo valve) is defective, so replace it. Table 1 20-212 YES 1 Is throttle inside 3 YES servo or filter inside Does condition be- servo clogged? come normal when YES PC valve (servo 2 valve assembly) is replaced? Is engine speed at arm NO NO relief normal?

See below NO Cause Remedy Clogged throttle inside servo or clogged filter inside servo Defective PC valve or defective adjustment of PC valve Defective servo piston See troubleshooting for engine (S mode) Clean Adjust or replace servo valve assembly Replace Replace (piston assembly) Enginespeedatarmrelief Conditions 1900rpm • Engineathighidling • SwinglockswitchON • Measurethespeedatthepointwherethedropinenginespeedis greatestwhenthearmcylinderisatendofstrokeandtheleveris operatedslowlytothefullposition.