TESTING AND ADJUSTING H-18 H-18 Travel speed does not switch or is faster than specified speed. # Carry out troubleshooting in the heavy- duty mode. (When travel PPC shuttle is normal.) Table 1 Output pressure of LS-EPC solenoid. Table 2. Output pressure of travel EPC 20-226 Is output pressure of NO travel EPC valve normal See table 2. YES Lo mode only 3 YES Is output pressure of YES travel speed selector 2 solenoid valve normal? Is output pressure of • 3.6±0.3 MPa YES LS-EPC solenoid (36.7 0 -3 kg/cm2) NO 1 valve normal? • Travel speed selector switch: high • See Table 1 • Turn travel switch ON Is travel pressure NO switch normal? • See Judgement Table Note:
NO If auto-deceleration is cancelled when travel is operated, system is normal. Cause Remedy Defective travel EPC valve Defective operation of travel speed selector servo piston in travel motor Defective operation of travel speed selector solenoid valve Defective operation of LS- EPC solenoid valve Defective travel pressure switch.
Replace Replace Correct or replace Correct or replace Replace Lo Mid Hi 2.0±0.2MPa {20±2kg/cm2} 0.59±0.2MPa {6 ±2kg/cm2} 0.2±0.2MPa {2 ±2kg/cm2} •Engineathighidling •Travelpedalatfinecontrolposition •(autodecelerationcancelled) Lo Mi Hi 1.4±0.2 MPa (14±2 kg/cm2) 29.4+ 0.4 MPa - 0.2 (30+ 4 kg/cm2) - 2 29.4+ 0.4 MPa - 0.2 (30+ 4 kg/cm2) - 2 • Engine at high idling • Travel lever at fine control position •(autodeceleration cancelled) • Measure PPC pressure at main valve •(travel spool)