TESTING AND ADJUSTING TROUBLESHOOTING M-11 M-11 When starting switch is turned ON and engine is started, basic check items flash. # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. # Check both the alternator system and the engine oil pressure system. a) Alternator system. M-11a) Related electric circuit diagram 20-252 3 YES Does monitoring YES code 43 show a 2 value of greater than 100? YES Is voltage between • Start engine and run NO C03 (12) and chassis at midd-range or 1 normal? above.
• Set to monitoring Is voltage between • S att a mrt i de -n rag nin ge e a on rd run code 43. alternator terminal R above. NO and chassis normal? • 20-30V • Start engine and run at mid-range or above. NO • 20-30V. Cause Remedy Defective governor, pump controller Defective monitor panel Defective contact, or disconnection in wiring harness between alternator terminal D-E08 (2) - C03 (female) (12) Defective alternator Replace Replace Repair or replace Replace.