TESTING AND ADJUSTING TROUBLESHOOTING M-10 M-10 Preheating is not being used but (preheating monitor) lights up # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. Is voltage between P01(18) and chassis normal? 2 YES Defective motor panel Replace YES 1 Wiring harness between starting switch R1 - X07 (3) - H13 (6) - P01 (female) (18), or between E11 and H13 ( female) (6) short circuiting with power source Repair or replace Is voltage between starting switch terminal R1 and chassis normal? Turn starting switch ON. Max. 1V. NO Disconnect terminal R1.
Turn starting switch ON. Max. 1V. NO Defective starting switch Replace M-10 Related electrical circuit diagram 20-251 Cause Remedy