Komatsu — M- 13 When starting switch is turned ON and engine is started, caution items, emergency items flash ( when there is no abnormality in engine or items to check before troubleshooting).

TESTING AND ADJUSTING TROUBLESHOOTING M-9 d) (coolant temperature) flashes e) (fuel level) flashes M-13 e) Related electric circuit diagram. 20-257 # Check that the coolant temperature is normal before Cause Remedy carrying out troubleshooting. Defective coolant temperature - YES sensor system 2 (see M-26) When P07 is YES disconnected, does only level 1 (left end) of gauge display light up? 3 YES Defective governor, pump Replace 1 Is resistance controller • Start engine. between C03 Is coolant NO (female) (1) - (16) - Short circuit of wiring harness Repair or temperature in red chassis normal? between C03 (female) (A) - E08 replace range?

• Turn starting switch NO (6) - Position07 (female) (1) and OFF wiring harness between C03 • Start engine and run • Disconnect C03 and (female) (16) - E08 (11) - P07 at mid-range or P07 (female) (B) above. • Max. 1MΩ NO Defective monitor panel. Replace M-13 d) Related electric circuit diagram. Cause Remedy M-13 d) Related electric circuit diagram. # Check that there is fuel before carrying out troubleshooting. YES 2 When P06 (female) (1) YES is connected to chassis ground, do all lamps to level 14 (right end) of 3YES gauge display light up? 1 Is voltage between • Start engine. C03 (2) and (16) • Wait for approx. 2 NO normal? Is fuel gauge in red minutes. (The fuel range?

l de iv se pl l am y a isy gv ia vr ey n, s ao the - (C 1o ) n ton e cc ht a P s0 s6 is ( gfe rom ua nl de . NO • Start engine. time delay). - Turn starting switch ON. - Max. 0.3V NO Cause Remedy Defective fuel level sensor system (see M-25) Defective governor, pump controller Defective contact or disconnection in wiring harness between C03 (female) (2) and P06 (female) (1) Defective monitor panel. - Replace Repair or replace Replace