DISASSEMBLY AND ASSEMBLY SWING MACHINERY ASSEMBLY OF SWING MACHINERY ASSEMBLY # Clean all parts, and check for dirt or damage. Coat the sliding surfaces of all parts with engine oil before in- stalling. 1. Bearing outer races Using push tool, press fit outer races (34) and (35) to case (33). 2. Shaft assembly 1) Fit O-ring to inside of collar (30), and install to shaft (31). 2) Using push tool , press fit bearing (29) with press. 3) Set case assembly (36) to shaft assembly (28). 4) Using push tool , press fit bearing (26) to a po- sition where it is possible to insert split collar. # Press fitting force: 11.76 kN (1,200 kg). # Rotate the case and gradually press fit the bearing.
5) Install split collar (25). 6) Screw bolt (Thread dia. = 12 mm, Pitch = 1.75 mm) into case, then using push-pull scale , measure tangential force in direction of rotation. # Tangential force: Max. 176.4 N (18 kg). # The tangential force is the maximum force when starting rotation. 30-25