Komatsu — ASSEMBLY OF SWING MACHINERY ASSEMBLY

DISASSEMBLY AND ASSEMBLY SWING MACHINERY 3. Oil seal Using push tool , press fit oil seal (32). # Replace the oil seal with a new part. Lip of oil seal: Grease (G2-LI). 4. Retainer Install retainer (24). 5. No. 2 carrier assembly 1) Assemble No. 2 carrier assembly as follows. i) Assemble bearing (22) to gear (21). ii) Fit top and bottom thrust washers (20) and (23), then set gear assembly to carrier (19). iii) Align position of pin holes of shaft and car- rier, then tap with a plastic hammer to install shaft (18). # When installing the shaft, rotate the planetary gear and be careful not to damage the thrust washer. iv) Insert pin (17).

# After inserting the pin, caulk the pin por- tion of the carrier. 30-26