Komatsu — INSTALLATION OF REVOLVING FRAME ASSEMBLY

DISASSEMBLY AND ASSEMBLY REVOLVING FRAME INSTALLATION OF REVOLVING FRAME ASSEMBLY Carry out installation in the reverse order to removal. 1 # Adjust the governor motor rod. For details, see TESTING AND ADJUSTING, Adjusting governor motor rod. 2 Mating surface of swing circle: Gasket sealant (LG-1) Thread of revolving frame mounting bolt: Thread tightener (LT-2) Revolving frame mounting bolt: 227.1 ± 31.9 Nm (28.3 ± 3.3 kgm) Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air. For details, see TESTING AND ADJUSTING, Bleeding air.

Refilling with water # Add water through the water filler to the specified level. Run the engine to circulate the water through the system. Then check the water level again. 30-31