Komatsu — REMOVAL OF REVOLVING FRAME ASSEMBLY

DISASSEMBLY AND ASSEMBLY REVOLVING FRAME REMOVAL OF REVOLVING FRAME ASSEMBLY Lower the work equipment completely to the ground and stop the engine. Then loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Remove the hydraulic tank strainer, and using tool B , stop the oil. When not using tool B , remove the drain plug, and drain the oil from the hydraulic tank and in- side the system. Hydraulic tank: Approx. 100 l . Disconnect the cable from the negative (-) terminal of the battery. 1. Remove 2 boom cylinder assemblies. For details, see REMOVAL OF BOOM CYLINDER ASSEMBLY. 2. Remove work equipment assembly. For details, see REMOVAL OF WORK EQUIPMENT ASSEMBLY. 3.

Remove counterweight assembly. For details, see REMOVAL OF COUNTERWEIGHT ASSEMBLY. 4. Disconnect top mounting hoses of swivel joint assem- bly. For details, see REMOVAL OF SWIVEL JOINT ASSEMBLY. Remove torque arm (1). 5. Remove mounting bolts, then lift off revolving frame assembly (12). # Leave 2 bolts each at the front and rear, use a lever block to adjust the balance of the revolving frame assembly to the front and rear, and left and right, then remove the remaining bolts, and lift off. 3 When removing the revolving frame assem- bly, be careful not to hit the center swivel joint assembly. Revolving frame assembly: 3,300 kg. 30-30