DISASSEMBLY AND ASSEMBLY FRONT AXLE FINAL DRIVES Unscrew the screws (2) of the carrier assy (3). Remove the planetary carrier from the wheel hub, us- ing a puller two screws and operating on the extraction holes. Partially unscrew the screws (4) and knock with a plastic hammer to separate the planetary carrier (5). Then remove the screws. When reassembling, clean and degrease the planetary carrier (5) union surface to the carrier assy (3) and use Loctite 510. Check the condition of the needle bearing (6) and washers (7). Replace, if necessary. Check the planetary pin (8) conditions. As they are forced on the planetary carrier (3), replace the whole planetary carrier if damaged.
When reassembling, if necessary, use some grease to hold in position the needle bearing. Turn the wheel hub and position the plug (1) to the upper point. Fill it with specified oil. Turn the wheel hub setting the plug (1) in horizontal position, then check the oil level. 30-43