Komatsu — WHEEL HUBS AND BRAKES

DISASSEMBLY AND ASSEMBLY FRONT AXLE WHEEL HUBS AND BRAKES Remove the ring (1), the reaction plate (2), the brake disc (3) and the reaction plate (4). Unscrew the screws (5) and remove the wheel carrier (6) and crown gear (7) by using the two extraction holes M12. Recover the two O-ring (12) on brake fluid inlet ports. Separate the wheel carrier from the crown gear and remove the centering bushes (8). Extract the wheel hub (9). Replace the O-ring (11). Check the brake disc (3) for deformation or burning traces; replace, if necessary. Check that the disc friction material thickness is not lower than 3.9 to 4.2 mm; replace, if necessary.

Check the reaction plates (2) and (4) do not show any signs of excessive wear or grooves exceeding 0.20 mm. 30-44