Komatsu — SWIVEL PIN BEARING CLEARANCE

DISASSEMBLY AND ASSEMBLY FRONT AXLE SWIVEL PIN BEARING CLEARANCE The swivel pin bearings are set with 0.00 to 0.10 mm of clearance. Make this operation adding or subtracting shims (6) between king pins (7) and (8) and the swivel housing (9). Do the following procedure: Install the bottom pin (8) with shims (for example 1.00 mm) and fix by relative screws. Without any shims, install the top pin/bearing assem- bly (7) and fix by relative screws. Install a dial gauge on the top cover and take note of the clearance between knuckle and cover. Operate with a lever between knuckle and axle beam (example of measure: 0.50 mm). Subtract from this value the clearance required for the bearings:

0.50 - (0.00 to 0.10) = 0.50 to 0.40 mm. Subtract this value from the employed shims (1.00 mm). Divide by 2 to obtain the shims to employ under each cover: 1.00-(0.50 to 0.40) 2 = 0.25 to 0.30 mm. Remove the covers and install under each of them the shims established before: 0.25 to 0.30 mm. Tighten the set screw. 30-47