Komatsu — STEERING CYLINDER - TOE- IN

DISASSEMBLY AND ASSEMBLY FRONT AXLE STEERING CYLINDER - TOE-IN Steering cylinder Carry out the final adjustment. Turn the cyl- inder by the relative end seats, until the ad- justment is correct; you can dot it as the shafts (2) and (3) are threaded left and right hand. Inspect the steering cylinder rod (1) and its piston for wear or damages. Inspect the ball joints assy (2) and (3) for wear or dam- ages. Check for the distance (M) is the same both sides. If any leakage is evident, replace the steering cylinder seal kit. When the final adjustment is reached, lock the nuts (4) and (5) to 300 Nm. Toe-in The toe-in value has to be of +1 to -1 mm (measured on the hubs flange).

To adjust follow this procedure: Tighten the shafts threaded (2) and (3) onto the cylin- der until approaching the final adjustment value. Then connect the shafts threaded (2) and (3) to the tie rods (6) and (7) by the corresponding pins (8). 30-49