Komatsu — BRAKES

DISASSEMBLY AND ASSEMBLY REAR AXLE BRAKES Unscrew the bolts (11) and remove the wheel shaft (8). Check the oil seal (10) conditions; replace, if neces- sary. Lubricate and use a correct seal driver to avoid damaging during the assembling. Check the bush (9) conditions; replace, if necessary. Check the brake disc (1) for deformation or burning traces; replace if necessary. Check that the disc friction material thickness is not lower than 7.9 to 8.3 mm; replace, if necessary. Check the splines conditions on the side shaft (2) and on the sleeve (3). Check the brake piston (4) and the reaction plate (5) do not show any signs of excessive wear or grooves exceeding 0.20 mm.

Replace the quadrings (6) and (7). 30-64