DISASSEMBLY AND ASSEMBLY REAR AXLE ADJUSTMENT OF THE FLANGE ON THE PINION The motion input flange (4) should be mounted with some adjusting shims (3) between washer (2) and bevel pinion in order to ensure a correct assembling. In order to measure the dimension (S) of the shims to be used, it is necessary to mount the washer (6) with- out O-ring (5), and then the flange (4). Measure dimension (S) by using a gauge. Remove flange (4), remount O-ring (5) and flange (4). Interpose the shims (3) whose size has been previ- ously determined. Apply loctite 510 between washer (2) and pinion. Tighten screw (1) at 139 Nm. 30-69