DISASSEMBLY AND ASSEMBLY REAR AXLE BEVEL PINION-GEAR TEETH BACKLASH The backlash has to be 0.21 to 0.28 mm. The adjustment is carried out operating on the side adjustment ring nuts. The ring nuts, pressing on the bearings, bring the crown to- wards or away from the pinion. Operate in the following manner: Turn the ring nut, crown side, clockwise till getting con- tact between the crown and the pinion; at the same time use a plastic hammer in order to settle the bear- ing. Turn the other ring nut clockwise, and at the same time use a plastic hammer in order to eliminate any bearing backlash. You can get such a condition when the ring nut rotation becomes difficult.
Position the dial gauge so that the probe is in contact with it, and at 90o to a tooth of the pinion. Measure the backlash between pinion and bevel gear. Repeat the operation on two or more points (teeth) turning the pinion and remarking the backlash value. If the amount of backlash is different, put the probe on the tooth that has the smallest backlash. Bring the crown towards or away the pinion turning each ring nut in the same way, until the specified back- lash is achieved. DIFFERENTIAL BEARINGS PRE-LOAD To carry out the adjustment operate as follows:
With the crown engaged to the pinion, and having ob- tained the correct backlash between pinion and bevel gear, turn the pinion by using a dynamometer with the string wrapped around the queue of the pinion itself. Measure the value of the stress necessary to rotate both the pinion and the differential simultaneously. Turn each ring nut to the same extent (tighten or loosen) in order to maintain the same backlash value. The total pre-load (T) of the bearings (pinion + differential) measured on the queue of the pinion must be the following: T = (P+29) to (P+44) N where P is the actual pre-load measured on the pinion. 30-68