Komatsu — PINION BEARING PRE- LOAD

DISASSEMBLY AND ASSEMBLY REAR AXLE PINION BEARING PRE-LOAD The bearing pre-load must be 84 to 126 N, measured on the queue of the pinion outer diameter. Tighten progressively the ring nut until the established pre-load value results. To control the pre-load, use a dynamometer with the rope twist on the pinion queue. When the roating torque is a specified, peen the edge of the ring nut to lock the nut to the shaft (avoid use of sharp punches or chisels). 30-67