DISASSEMBLY AND ASSEMBLY REAR AXLE PINION POSITIONING Bevel distance Install the pinion bearings in their seat in the differen- tial end plate and put them in contact using the tool (1); it must be possible to turn the conical bearings by hand, never close tight. Assemble the central gear half-cover and fasten it with relative screws. With the aid of an internal micrometer measure the diameter (D), bearing seat. Put a calibrated rod (2) into the central gear bearing seat and, by using a depth gauge, measure level (Y). Carry out the following operation: B = Y - 25 (calibrated rod diameter) + D/2.
In order to determinate the thickness to be inserted between the pinion and the bearing, simply subtract from the (B) value the one stamped on the pinion head. Create this thickness by using the range of the rings on hand, and inserting them in the pinion shaft. Insert the bearing in the pinion shaft, and ensure that it is completely seated. 30-66