DISASSEMBLY AND ASSEMBLY CONTROL VALVE 9. Remove connector (24) from clip, then disconnect it. # Disconnect the wiring harness from the harness clamps (3 places). 10. Remove harness bracket (25). 11. Disconnect hose (26). 12. Remove mounting bolts, and lift off control valve as- sembly (27). Control valve assembly: 100 kg. INSTALLATION OF CONTROL VALVE ASSEMBLY Carry out installation in the reverse order to removal. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air from the circuit between the valve and the hydraulic cylinder.
For details, see TESTING AND ADJUSTING, Bleeding air. 30-80