DISASSEMBLY AND ASSEMBLY PRESSURE COMPENSATION VALVE DISASSEMBLY OF PRESSURE COMPENSATION VALVE ASSEMBLY Disassembly of pressure compensation valves A, B, C, D The structure of the parts for pressure compensation valves A, B, C, and D is the same, but the part number for the assem- bly marked # is different, so be careful when assembling. Disassembly of pressure compensation valve E 1. Remove piston (13) and spring (14) from sleeve (12). 2. Remove seals (15) and (16) from piston (13), then remove O-ring (17), seals (18) and (19), and O-ring (20) from sleeve (12). 1. Remove piston (2) and spring (3) from sleeve (1).
# After disassembling, if there is any abnormality in sleeve (12), piston (13), or seals (15) and (16), replace the whole pressure compensation valve assembly. 2. Remove plug (4) and ball (5) from piston (2). 3. Remove seals (6) and (7) from piston (2). 4. Remove O-ring (8) from sleeve (1), then re- move seals (9) and (10), and O-ring (11). IDENTIFICATION OF PRESSURE COMPENSATION VALVE ASSEMBLY # After disassembling, if there is any abnormality in sleeve (1), piston (2), plug (4), ball (5), or seals (6) and (7), replace the whole pressure compensation valve assembly. Valves are identified by markings on the valve assembly. Type A - 1 mark. Type B - 2 marks (side by side). Type C - 3 marks.
Type D - 4 marks. Type E - 2 marks (separated). 30-87