DISASSEMBLY AND ASSEMBLY LS VALVE REMOVAL OF LS VALVE ASSEMBLY Disconnect the cable from the negative (-) terminal of the battery. Lower the work equipment completely to the ground and stop the engine. Then loosen the oil filler cap slowly to release the pressure inside the hydraulic tank. Remove the hydraulic tank strainer and, and using tool B , stop the oil. When not using tool B , remove the drain plug, and drain the oil from the hydraulic tank and in- side the system. Hydraulic tank: Approx. 100 l . 1. Disconnect hose (1). 2.
Fit wrench to hexagonal width across flats of sleeve, then loosen and remove LS valve assembly (2) 1 INSTALLATION OF LS VALVE ASSEMBLY Carry out installation in the reverse order to removal. 1 LS valve assembly: 139.7 ± 12.3 Nm {14.75 ± 1.25 kgm} Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. 30-93