Komatsu — REMOVAL OF ARM CYLINDER ASSEMBLY

DISASSEMBLY AND ASSEMBLY ARM CYLINDER REMOVAL OF ARM CYLINDER ASSEMBLY Extend the arm cylinder piston rod approx. 200 mm, lower the work equipment completely to the ground, then set the remaining safety lock lever to the LOCK position. 1. Set block between arm cylinder and boom. 2. Remove plate, then remove head pin (1). # There are shims installed, so check the number and thickness, and keep in a safe place. 1 3. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out. Release the remaining pressure in the hydraulic circuit. For details, see TESTING AND ADJUSTING, Re- leasing remaining pressure in hydraulic circuit. 4. Disconnect hoses (2). 5.

Disconnect grease tube (3). 6. Sling arm cylinder assembly, remove plate, remove bottom pin (4), then remove arm cylinder assembly (5). # There are shims installed, so check the number and thickness, and keep in a safe place. 2 Arm cylinder assembly: 170 kg. 30-99