DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER ASSEMBLY OF HYDRAULIC CYLINDER ASSEMBLY (THREADED PISTON TYPE) # Be careful not to damage the packings, dust seals, and O-rings. # Do not try to force the backup ring into position. Warm it in warm water (50 - 60 ° C) before fitting it. 1. Assembly of cylinder head assembly 1) Using tool H5 , press fit bushing (20). 2) Assemble buffer ring (19). 3) Assemble rod packing (18). 4) Using tool H6 , install dust seal (17), and secure with snap ring (16). 5) Install backup ring and O-ring (15). 2. Assembly of piston assembly 1) Using tool H3 , expand piston ring (13).
# Set the piston ring on the tool H3 , and turn the handle 8 - 10 times to expand the ring. 2) Set tool H4 in position, and compress piston ring (13). 3) Install backup ring and O-ring (14). 4) Assemble wear rings (12). 5) Assemble rings (11). # Be careful not to open the end gap of the ring too wide. Ring groove: Grease (G2-LI). 30-111