DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER 3. Piston rod assembly 1) Set piston rod assembly (2) in tool H1. 2) Assemble head assembly (7). 3) Fit O-ring and backup ring, to collar (6), and as- semble. Arm cylinder only. 4) Assemble plunger (5). Arm cylinder only. # Check that there is a small amount of play at the tip of the plunger. 5) Set cushion plunger (10) to piston rod, assemble 11 balls (9), then secure with cap (8). Arm cylinder only. 6) Assemble piston assembly (4) as follows: When using rod and piston assembly (2) again: # Wash thoroughly and remove all metal particles and dirt.
i) Screw in piston assembly (4), then use tool H2 to tighten piston assembly (2) until positions of screw holes are aligned. # Use a file to remove all burrs and flashes from the thread. iii) Tighten screw (3). Screw: 66.2 ± 7.35 Nm {6.75 ± 0.75 kgm} 30-112