Komatsu — ASSEMBLY OF HYDRAULIC CYLINDER ASSEMBLY ( THREADED PISTON TYPE)

DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER III) Caulk thread at 2 places with punch. When using a new part for one or both of rod and pis- ton assembly (2): # For rods with a bottom cushion, make a mark on the end face of the rod to show the position of the cushion plug. Arm cylinder only. i) Screw in piston assembly (4) until it contacts the end face of the rod, then tighten with tool H2. Piston assembly (4): 294 ± 29.4 Nm {30 ± 3.0 kgm) # After tightening the piston, check that there is play in plunger (5). Boom, arm cylinder only. ii) Machine one screw hole to install screw (3). # Align a drill with the V-groove in the thread of rod (2) and piston (4) and machine the hole horizontally.

# For cylinders with a bottom cushion (arm cyl- inder), avoid the position of the cushion plug when machining. Screw machining dimension (mm) iii) After machining, remove all metal particles and dirt, and wash thoroughly. iv) Tighten screw (3). Screw (3): 66.2 ± 7.35 Nm {6.75 ± 0.75 kgm} v) Caulk thread at 2 places with punch. 30-113 Bottomdrill diameter Bottomdrill depth Tapsize Tapdepth 10.3 27 12x1.75 20