DISASSEMBLY AND ASSEMBLY HYDRAULIC CYLINDER 7) Assemble piston rod assembly (2). Seal: Grease (G2-LI) # Set the end gap of the ring at the horizontal (side) position, align the center of shaft and cylinder tube, then insert. # After inserting, check that the ring is not broken and has not come out, then push in fully. 8) Tighten head assembly (1) with mounting bolts. Mounting bolt: Cylinder Tightening torque Bucket 172 ± 25 Nm {17.5 ± 2.5 kgm} Arm 270 ± 39 Nm {27.5 ± 4.0 kgm} Boom 172 ± 25 Nm {17.5 ± 2.5 kgm} 9) Install piping. 30-114