DISASSEMBLY AND ASSEMBLY WORK EQUIPMENT REMOVAL OF WORK EQUIPMENT ASSEMBLY Extend the arm and bucket fully, retract 2nd boom fully, lower the work equipment to the ground, and set the safety lock lever to the LOCK position. 1. Disconnect grease hose (1). 2. Sling boom cylinder assembly (2), and remove lock bolt (3). 1 3. Remove plate, then remove head pin (4). # There are shims installed, so check the number and thickness, and keep in a safe place. 2 4. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out, and lower it onto block. # Disconnect the boom cylinder on the opposite side in the same way.
Release the remaining pressure in the hydraulic circuit. For details, See TESTING AND ADJUSTING, Releasing remaining pressure in hydraulic circuit. 5. Remove clamp (5), and disconnect hoses (6) and (7), then secure it to valve with rope. 6. Disconnect wiring connector (8) for working lamp. 7. Sling work equipment assembly, remove plate, then remove foot pin (9) using tool I , and remove work equipment assembly (10). # There are shims installed, so check the number and thickness, and keep in a safe place. 3 Work equipment assembly: 1 Piece Boom - 1,900 kg 2 Piece Boom - 2,200 kg 30-115