Komatsu — REMOVAL OF ARM ASSEMBLY

DISASSEMBLY AND ASSEMBLY ARM REMOVAL OF ARM ASSEMBLY 1. Remove bucket assembly. For details, see REMOVAL OF BUCKET ASSEMBLY. 2. Secure front link to arm with wire. 3. Pull in arm so that is easy to remove pin at arm cylin- der head, then lower arm and bucket cylinder assem- bly (1) on to block . Set the safety lock lever to the LOCK position. 4. Set block between arm cylinder and boom. 5. Remove plate, then remove arm cylinder head pin (2). # There are shims installed, so check the number and thickness, and keep in a safe place. 1 6. Start engine, and retract piston rod, then tie piston rod with wire to prevent it from coming out. Release the remaining pressure in the hydraulic circuit.

For details, see TESTING AND ADJUSTING, Re- leasing remaining pressure in hydraulic circuit. 7. Disconnect 2 hoses (3) and 2 hoses (4). # Install blind plugs at the male end and in the dis- connected hoses. 8. Remove plate, then remove connecting ping (5) be- tween arm and boom. # There are shims installed, so check the number and thickness, and keep in a safe place. 2 9. After raising boom, swing to remove arm and bucket cylinder assembly (1). Arm - Bucket cylinder assembly: 550 kg. 30-119