DISASSEMBLY AND ASSEMBLY BUCKET INSTALLATION OF BUCKET ASSEMBLY Carry out installation in the reverse order to removal. 1 3 # When tightening the locknut, tighten so that the clearance between the plate and nut is 0.5 - 1.5 mm. 2 Inside surface of bushing when assembling pin: Anti-friction compound (LM-P). Grease after assembling pin: Grease (LM-G). When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance between bucket boss (7) and link (8) is below 1 mm. # Standard shim thickness: 1.0 mm, 2.0 mm. 4 Inside surface of bushing when assembling pin, inside surface, end face of collar (10):
Anti-friction compound (LM-P). Grease after assembling pin: Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole. # Set the O-ring at the end face of the bucket boss securely. # Adjust the shim thickness so that the clearance between arm top (9) and spacer (10) is below 0.5 mm. # Standard shim thickness: 0.5 mm, 1.0 mm. 30-118