Komatsu — INSTALLATION OF BUCKET - ARM ASSEMBLY

DISASSEMBLY AND ASSEMBLY BUCKET • ARM INSTALLATION OF BUCKET - ARM ASSEMBLY Carry out installation in the reverse order to removal. 1 Inside surface of bushing when assembling pin: Anti-friction compound (LM-P). Grease after assembling pin: Grease (LM-G). When aligning the position of the pin hole, never insert your fingers in the pin hole. # Adjust the shim thickness so that the clearance between cylinder rod (6) and bracket (7) is below 1 mm. # Standard shim thickness: 1.0 mm. 2 Inside surface of bushing when assembling pin: Anti-friction compound (LM-P). Grease after assembling pin: Grease (LM-G) When aligning the position of the pin hole, never insert your fingers in the pin hole.

# Adjust the shim thickness so that the clearance between boom top (8) and arm bottom (9) is be- low 0.5 mm. # Standard shim thickness: 0.5 mm, 1.0 mm. Refilling with oil (hydraulic tank) # Add oil through the oil filler to the specified level. Run the engine to circulate the oil through the system. Then check the oil level again. Bleeding air # Bleed the air from the cylinder. For details, see TESTING AND ADJUSTING, Bleeding air from hydraulic cylinder. 30-122