DISASSEMBLY AND ASSEMBLY ADAPTER WELDING INSTRUCTION • ELECTRODE WELDING ADAPTER WELDING INSTRUCTION - ELECTRODE WELDING BE SAFE! When performing the procedures described in this catalog, you should wear OSHA-approved hard hat, safety glasses, work gloves and safety shoes. IMPORTANT! ESCO weld-on Helilok adapters are hardened typically to 415BHN. In order to eliminate cracking commonly associ- ated with welding steel at these hardness levels, follow these procedures carefully and employ good welding tech- niques and practices. Summary of Welding procedures Mating surfaces to be welded should be shiny base metal, free of carbon arc surface, hardfacing, grease or dirt.
Use E-7016 or E-7018 low-hydrogen electrodes (keep dry!), or E-70T-5 low-hydrogen wire. Preheat the lip and adapter to 200 ° F (95 ° C); 350 ° to 400 ° F (117 ° to 204oC) if surrounding air temperature is 40 ° F (5 ° C) or less. Measure temperature with a Tempilstik (r). Maintain preheat temperature while welding. Maximum interpass temperature should not exceed 500oF (260 ° C). After welding, postheat to 350o to 400 ° F (117 ° to 204 ° C) if surrounding air temperature is 40oF (5 ° C) or less, then let air-cool. If air temperature is above 40oF, postheating is not necessary. Welds should fill J-grooves to a 45o angle.
If an adapter does not have a J-groove, apply fillet welds according to the following: Bucket Size (volume) Yards 3 Meter 3 Fillet Size 2 1.8 1/2" (13 mm) 2 1/4 - 5 2 - 4.6 5/8"(16 mm) 5 1/2 - 12 5 - 11 3/4"(19 mm) above 12 above 11 1"(25 mm) For complete welding information and procedures, refer to ESCO Products Maintenance Manual, Catalog 100-A, "How to weld ESCO alloy 12 series". Lip Adapter Installation 1. Locate the adapters on a clean bucket, then tackweld them in place, followed by a root layer all the way around. 30-133